Apply, set up WiFi and register your HAM DinMeter3P device (Android)
Ilias Dadis
Last Update 2 yıl önce
Once the device has been installed, the next step is to install the application and configure the WiFi so that the device can communicate with the application.
Application installation steps
- Download the app from the Play Store
- Create a new account
- Confirm account creation by following the link sent to your email.
WiFi setup steps
- Press the "add" symbol (+) that appears in the Devices menu.
- Select the category of the DinMeter3P.
- Give the HAM application the right to locate.
- Select the WiFi network and enter the code in the corresponding fields.
- Check carefully that we have not made any spelling mistakes.
- Press the Next button
- Go to the HAM DinMeter3P device and press the setup button until the green LED starts flashing.
- Go back to the application and press Next.
- Wait for it to send the codes and watch the green LED until it stays solid green.
If we have followed all the steps correctly and have not made any spelling mistakes in the network name and password, the green LED will remain lit and a window will appear for us to enter the D/K of our device.
Device registration steps
If we have followed all the steps to configure the wifi but the window for registering the device has not appeared, we must do the following.
- Check that the device is on and the green light is on permanently
- Click on the "add" symbol (+) that appears in the devices menu
- Select the last button that says "Add device"
- Enter the D/K of the device in the blank and press "Submit"