First alternative method of setting up a WiFi device HAM DinSwitch (iPhone)
Ilias Dadis
Last Update 2 tahun yang lalu
By following the steps outlined in the article on setting up WiFi, our network data may fail to send within the time limit. If this occurs, we will follow these steps.
WiFi setup steps
- Press the "add" symbol (+) that appears in the devices menu
- Select the category that the DinSwitch has
- Enter the WiFi network name and password in the corresponding fields
- Carefully check that we have not made a spelling mistake
- Press the button that says "Next"
- Go to the HAM DinSwitch and press the setup button until the green LED starts flashing
- Go back to the application and press "Next"
- Make sure the LED is flashing green
- Once the preset time limit has passed we make sure that we are presented with a list of options
- From the list that appears we select "flashing"
- In the menu that appears we select the button that says "Alternatives"
- On the page it takes us to we select the blue letters that say "Settings"
- It takes us to the mobile network settings where we are looking for the network named HAMXX_XXXX
- Connect to the network HAMXX_XXXX by entering the D/K of our device as a code
- Wait until it connects and once we are sure we go back to the application (There is a possibility that it says there is no network connection)
- In the options we are presented with we select that the green LED is blinking
- On the new page that appears we scroll to the bottom and select the blue numbers "192.168.4.1"
- Check the green LED, once it stays green we are taken back to the application.
If we have followed all the steps correctly and ensured there are no spelling mistakes in the network name or password, the green LED will remain lit. This will prompt a window to appear where we need to enter the D/K of our device.
Device registration steps
If we have followed all the steps to configure the wifi but the window for registering the device has not appeared, we must do the following.
- Check that the device is on and the green light is on permanently.
- Click on the "add" symbol (+) that appears in the devices menu.
- Select the last button that says "Add device".
- Enter the D/K of the device in the blank and click "Submit".