Create a measurement report on the HAM DinSwitch device
Ilias Dadis
Last Update 6 ay önce
1. In the "Devices" tab, select the device for which you wish to create the report and select "More".
2. Under the device graphs, select the "Reports" tab.
3. Select the measurement you are interested in (e.g. "Energy"), the time interval for which the report will be ("From-To"), the step (i.e. for how many hours readings will be displayed for each) and the format in which you want to download the report, PDF for printing or CSV (e.g. for reading from Excel).
4. Finally, click the "Create" button to download the report
It's crucial to request data for reporting only when it falls within reasonable and realistic limits. For instance, we shouldn't ask for an energy record for a period when the device wasn't in operation, as the values displayed will be incorrect or there may be no data at all. Additionally, when requesting a report, we may encounter a message indicating that no data is available
There are two possible reasons for this issue. It could be because we selected a time interval during which there was no recording due to a device disconnection, or because we chose to view data for a measurement that our device isn't recording. For instance, if we use DinSwitch to request recordings for current without having connected a transformer to record it, there won't be any data to display. The same situation will occur if we attempt to retrieve data while the device is disconnected from the power source or out of power.
If the device gets disconnected due to internet issues or a power outage, the report will display the last recorded temperature for the initial 12 hours. After this period, the report will show "N/A" for as long as the device remains out of service. The same will occur if there is a sensor fault, causing measurements to stop and the report to display "N/A" until the issue is resolved.